Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 60)

FEED Key and PAUSE Key

Press and hold these two keys while turning the print engine power ON. The print

engine configuration will be temporarily reset to the factory default values. These val-

ues will be active until power is turned OFF.

NOTE: If the factory default values are permanently saved, a media calibration pro-

cedure must be performed. You must also reset the head resistance value, and the ver-

ifier and applicator port settings to their required values (see “Configuration &

Calibration” on page 21).

Table 8: Configuration Parameters

Parameter Controlled by

Darkness Configuration and ZPL

Tear Off Configuration and ZPL

Print Mode Configuration and ZPL

Media Type Calibration, Configuration and ZPL

Sensor Type Configuration and ZPL

Print Method Calibration, Configuration and ZPL

Print Width Configuration and ZPL

Label Length Calibration, Configuration and ZPL

Maximum Length Configuration and Memory Size

Host Port Configuration

Baud Configuration

Data Bits Configuration

Parity Configuration

Stop Bits Configuration

Host Handshake Configuration

Protocol Configuration

Network ID Configuration and ZPL

Communications Configuration and ZPL

Control Prefix Configuration and ZPL

Format Prefix Configuration and ZPL

Delimiter Character Configuration and ZPL

ZPL Mode Configuration and ZPL

Ribbon Tension Configuration and ZPL

Media Power Up Configuration and ZPL

Head Close Configuration and ZPL

Backfeed Configuration and ZPL

Label Top Configuration and ZPL

Left Position Configuration and ZPL

Head Test Count Configuration and ZPL

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 60