Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 33)

100

NETWORK ID

Setting Network ID Press the LEFT BLACK OVAL key to move to the

next digit position, press the RIGHT BLACK OVAL key to increase the value

of the digit.

Default: 000

Selections: 000 - 999

Network ID is used to assign a unique number to a print engine used in an RS-

422/RS-485 network. This gives the host the means to address a specific print

engine. If the print engine is used in a network, you must select a network ID

number. This does not affect TCP/IP or IPX/SPX networks.

COMMUNICATIONS

Setting Communications Mode Press the RIGHT or LEFT BLACK

OVAL key to display other choices.

Default: Normal mode

Selections: Normal mode, diagnostics

The communication diagnostics mode is a troubleshooting tool for checking the

interconnection between the print engine and the host. When “diagnostics” is

selected, all data sent from the host to the print engine will be printed as straight

ASCII hex characters. The print engine prints all characters received including

control codes, like CR (carriage return). A sample printout is shown in

Figure 16 on page 60.

NOTE: Diagnostic printouts:

• An FE indicates a framing error.

• An OE indicates an overrun error.

• A PE indicates a parity error.

• An NE indicates noise.

For any errors, check that your communication parameters are correct. Set the

print width equal to or less than the label width used for the test. See “PRINT

WIDTH” on page 24 for more information.

Selecting Prefix and Delimiter Characters

Prefix and delimiter characters are 2-digit hex values used within the ZPL/ZPL II formats sent to the print engine. The

print engine uses the last prefix and delimiter characters sent to it, whether from a ZPL II instruction or from the front

panel.

NOTE: DO NOT use the same hex value for the control, format, and delimiter character. The print engine must see

different characters to function properly.

CONTROL PREFIX

Control Prefix Character Press the LEFT BLACK OVAL key to move to

the next digit position, press the RIGHT BLACK OVAL key to increase the

value of the digit.

Default: 7E (tilde)

Range: 00-FF

The print engine looks for this 2-digit hex character to indicate the start of a

ZPL/ZPL II control instruction.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 99 100

Comentarios a estos manuales

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 33

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Zebra 170PAX2 Series