Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 28)

INITIALIZE CARD

Initialize Memory Card

CAUTION: Perform this operation only when it is necessary to erase all

previously stored information from the optional memory card. Press the

NEXT/SAVE key to bypass this function.

1. Press the RIGHT BLACK OVAL key to select “YES.”

If your print engine is set to require a password, you will now be prompted

to enter the password. enter the password and then press the NEXT/SAVE

key.

2. The display will ask “INITIALIZE CARD?”. Press the RIGHT BLACK

OVAL key to select “YES.”

3. The control panel LCD will ask “ARE YOU SURE?”.

4. Press the RIGHT BLACK OVAL key to select “YES.”

Press the LEFT BLACK OVAL key to select “NO” cancel the request and

return to the “INITIALIZE CARD” prompt.

5. Press the SETUP/EXIT key followed by the NEXT/SAVE key. If initializa-

tion is still in process, the control panel display will flash back and forth

between the two phrases “CHECKING B: MEMORY” and “PRINTER

IDLE.”

When initialization is complete, the print engine will automatically exit the

configuration mode and the control panel will display “PRINTER

READY.”

NOTE: Depending on the amount of memory in the memory card, initial-

ization may take up to five minutes to complete.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 28