Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 14)

Figure 4. Ribbon Loading (Right-Hand Units)

Left Hand Units

1. Push the ribbon roll onto the supply spindle (N) as far as it will go, so the ribbon

feeds as shown in Figure 5 on page 13.

2. Install an empty ribbon core onto the ribbon take-up spindle (O).

3. Open the printhead assembly (C) by unlatching the print- head lock lever (D) from

the locking pin (E).

4. Thread the ribbon below the lower ribbon guide roller (P), under the printhead

assembly (C), and up and over the upper ribbon guide roller (Q) as shown in

Figure 5. Use caution not to crease or wrinkle the ribbon!

5. Attach the ribbon to the take-up spindle core (use a label if needed) and wind for

several turns in the direction shown in Figure 5.

6. Close the printhead assembly (C) by latching the printhead lock lever (D) onto the

locking pin (E).

7. Insure the ribbon is located between the Ribbon Sensor and the Sensor Reflector

positioned above it.

OPEN

CALIBRA TE

SETUP /EXIT

PAU S E

CANCEL

FEED

DATA POWERERRORRIBBONMEDI APAU SE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 14