Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 38)

APPLICATOR PORT

Setting the Applicator Port Press the RIGHT or LEFT BLACK OVAL

key to display other choices.

Default: Off

Selections: Off, mode 1, mode 2, mode 3, mode 4

Determines the action of the verifier port.

• Off: The applicator port is off.

• Mode 1: Asserts the ~END_PRINT signal low while the printer is moving the

label forward.

• Mode 2: Asserts the ~END_PRINT signal high while the printer is moving

the label forward.

• Mode 3: Asserts the ~END_PRINT signal low for 20 milliseconds when a

label has been completed and positioned. Not asserted during continuous

printing modes.

• Mode 4: Asserts the ~END_PRINT signal high for 20 milliseconds when a

label has been completed and positioned. Not asserted during continuous

printing modes.

Printing Controls

START PRINT SIG

Setting the Start Print Signal Press the RIGHT or LEFT BLACK OVAL

key to display other choices.

Default: Pulse Mode

Selections: Pulse Mode, Level Mode

This parameter determines how the print engine will react to the Start Print Sig-

nal input on pin 3 of the applicator interface connector at the rear of the print

engine.

This is set by the applicator manufacturer and should not be changed unless the

factory defaults have been reloaded. Please make a note of it! While other

choices are valid, the print engine must be returned to its designated setting in

order for it to work properly.

Refer to “Cabling Requirements” on page 78 for more applicator cable informa-

tion.

PULSE MODE - A label will print when the signal transitions from HIGH to

LOW.

LEVEL MODE - Labels will print as long as the signal is asserted LOW.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 38