Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 39)

RESYNC MODE

Setting the Resync Mode Press the RIGHT or LEFT BLACK OVAL key

to display other choices.

Default: Feed Mode

Selections: Feed Mode, Error Mode

This parameter determines how the print engine will react if the label synchroni-

zation is lost and the label top is not where expected.

This is set by the applicator manufacturer and should not be changed unless the

factory defaults have been reloaded. Please make a note of it! While other

choices are valid, the print engine must be returned to its designated setting in

order for it to work properly.

FEED MODE - If the label top is not where expected, the print engine will feed

a blank label to find the label top position.

ERROR MODE - If the label top is not where expected, the print engine will

stop, enter the PAUSED mode, display the message “Error Condition Feed

Label”, flash the ERROR LED, and assert the “Service Required” signal (pin 10

on the Applicator Interface Connector).

To resync the media to the top of the label in this mode, the user must press the

PAUSE key to exit the PAUSED state. The ERROR LED will then stop flashing

and the “Service Required” signal will be de-asserted. The action of the print

engine is then determined by the “Head Close” configuration selection:

• “Calibration” - the print engine feeds labels and recalibrates the media sen-

sors.

• “Feed”- the print engine feeds the labels to the next web.

• “Length” - the print engine feeds labels and calculates the label length.

• “No Motion” - the media does not move. The user must press the FEED key

to cause the print engine to resync to the start of the next label.

RIBBON LOW MODE

Selecting the Ribbon Low Mode Press the RIGHT or LEFT BLACK

OVAL key to display other choices.

Default: Enabled

Selections: Enabled, Disabled

When the Ribbon Low feature is enabled, the “Ribbon Low” output signal (Pin

9) on the applicator port is functional. When the amount of ribbon on the supply

spindle reaches a specific low level, the output signal will assert HIGH to pro-

vide a “Ribbon Low” warning.

When the Ribbon Low feature is disabled, the output signal (Pin 9) will not

function, the “Low Ribbon” warning is not displayed, and the print engine will

continue to print until it runs out of ribbon.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 39