Zebra 170PAX2 Series Guía de usuario descargar pdf (Pagina 45)

Care & Adjustments

Cleaning

CAUTION: Use only the cleaning agents indicated. Zebra Technologies Corpora-

tion will not be responsible for damage caused by any other cleaning materials

used on the 170PAX3-Series print engine.

Table 4 provides a recommended cleaning schedule. Cleaning swabs saturated with

70% Isopropyl Alcohol are available from your Zebra distributor as a Preventive

Maintenance Kit (part # 01429).

Cleaning the Exterior

The exterior surfaces of the print engine may be cleaned with a lint free cloth. Do not

use harsh or abrasive cleaning agents or solvents! If necessary, a mild detergent solu-

tion or desktop cleaner may be used sparingly.

Cleaning the Interior

Remove any accumulated dirt and lint from the interior of the print engine using a soft

bristle brush and/or vacuum cleaner. This area should be inspected after every roll of

ribbon.

Cleaning the Sensors

To ensure proper operation of the print engine, all sensors should be cleaned on a regu-

lar basis. To locate the position of these sensors, refer to Figure 10 on page 44.

Table 4: Preventive Maintenance Schedule

Area Method Interval

See Figure 10 on page 44 and Figure 11 on page 45 for parts locations

Printhead (1) Alcohol After every roll of ribbon when printing in the thermal transfer mode.

After every roll of media when printing in the direct thermal mode.

Platen Roller (2) Alcohol

Media Path Alcohol

Transmissive Media Sensor (3) Air blow

Reflective Media Sensor (4) Air blow

Ribbon Sensor (5) Air blow

Door-Open Sensor (6) Air blow

Peel Bar (7) Alcohol After every roll of media or more often if needed.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 99 100

Sin comentarios

Zebra 170PAX2 Series Guía de usuario Pagina 45