Zebra Z6M Especificaciones descargar pdf (Pagina 108)

Page 4-48 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

Figure 4-39. Media Sensor Removal

,QVWDOO0HGLD6HQVRU$VVHPEO\

1. Refer to Figure 4-39. Install the new media sensor assembly into the carrier by

snapping the sensor portion into the carrier. Ensure that the button, spring and

insulator have the proper spring action by pressing down on the button and releasing

it.

2. Route the media sensor wires through the wireway on the platen roller assembly and

through the access hole in the printer frame. Replace cable ties that have been

previously cut. Connect the media sensor connector to the main logic board at P6.

3. Start the media sensor carrier through the slots provided on the platen roller

assembly. Gently press down on the media sensor carrier and push the carrier past

the stop.

4. Release the carrier and push it back and forth to make sure it travels its entire route

on the platen housing tracks. Reinstall the platen assembly latch cover.

5. Install the electronics cover. Replace media and ribbon in the printer and close the

media door. Reconnect power cord to the printer.

6. Turn the printer On (l) and print a configuration label using the Cancel Key Self

Test.

Platen Roller

Assembly

Media Sensor

Assembly

Media Sensor

Carrier

Media Sensor Holder

Mounting Tabs

Latch Cover

Note • Make sure to loop the wire harness inside the platen roller assembly

wireway. There should be no twists in the wire harness in the wireway. Ensure

that the media sensor assembly can travel its entire route.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 108