Zebra Z6M Especificaciones descargar pdf (Pagina 87)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-27

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

5HPRYH3ODWHQ5ROOHU

1. Turn the printer power OFF at the rear of the printer. Disconnect the AC power cord.

2. Open the media door and remove all media and ribbon from the printer.

3. Refer to Figure 4-15. Remove the electronic side cover by removing the one or two

screws that secure the cover to the printer.

4. Refer to Figure 4-16. Using a hex key, loosen the stepper motor locking screw and

the loosen the pivot screw. Pivot up the stepper motor and remove the drive belt.

5. Figure 4-22. Using a hex key loosen the two set screws on the compound pulley.

Remove the pulley and belt from the platen roller shaft.

Figure 4-22. Platen Roller Assembly (Z4M Shown)

6. Using a hex key, remove the two tear bar mounting screws. Remove tear bar.

7. Refer to Figure 4-22. Using two standard screwdrivers or needle nose pliers squeeze

and push up on the barbed legs of outer spring clip to disengage it from the platen

housing.

Note • Make note of the orientation of pulley and around which pulley the belt

is installed.

Platen

Housing

Assemby

Tear Bar

Mounting Screws

(2)

Set

Screws

(2)

Spring Clips

(2)

Bearings

(2)

Platten Roller

Curved Spring

Washer

Note • The inner spring clip does not have to be removed to remove the platen

roller and bearings.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 87