Zebra Z6M Especificaciones descargar pdf (Pagina 127)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-67

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

4. Carefully remove the plastic latch cover from the platen housing latch.

5. Slide the front cover to the right, then lift to remove.

6. Reinstall the plastic latch cover.

7. Refer to Figure 4-63. Loosen, but do not remove, the three screws that attach the

rear cover to the main frame and base.

Figure 4-63. Base Removal

8. Remove the screw that attaches the platen housing to the base. If there is a plastic

washer present, discard it.

9. Remove the four screws that attach the main frame to the base.

10. Lift the main frame off the base assembly.

,QVWDOO5HZLQG3DQ

1. Refer to Figure 4-63. Place the main frame onto the rewind pan assembly. Ensure

the rear ledge of the main frame rests completely on the rear support in the pan.

2. Install, but do not tighten, the main frame mounting screws provided in the kit. After

starting the screws, recheck the alignment from step 1. Tighten the two screws on

the rear of the main frame.

3. Tighten the rest of the main frame mounting screws.

Main Frame

Mounting Screws

Main Frame

Mounting Screws

Rear Cover

Mounting Screws

Platen Housing

Mounting Screw

Rear

Cover

Main Frame

Base

Assembly

Note • Do not remove the screws attaching the platen housing to the main

frame.

Note • Alignment is very important. The platen housing leg must be inside the

mounting tab of the rewind pan.

Note • The oversize mounting hole in the pan allows for adjustment of the front

of the pan to align with the door.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 127