Zebra Z6M Especificaciones descargar pdf (Pagina 98)

Page 4-38 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

,QVWDOO'ULYH%HOW

1. Install the belt on the correct pulley of the compound pulley.

2. Lift up on the stepper motor, place the belt onto the stepper motor drive gear.

3. Adjust the position of the stepper motor to achieve the correct belt deflection and

tighten the locking screw to secure the motor. Tighten the pivot screw.

4. Install the electronics side cover.

5. Reconnect the AC power cord and turn the power On (l).

6. Print a configuration label using the Cancel Key Self Test.

)URQW3DQHO5HSODFHPHQW

5HPRYH)URQW3DQHO

1. Turn the printer Off (O) and disconnect the AC power cord.

2. Refer to Figure 4-15. Open the media door and loosen the two screws to remove the

electronics cover.

3. Refer to Figure 4-31. Disconnect the front panel data cable from P7 on the main

logic board. Note the cable routing.

4. Locate the plastic grounding cable near the top of the inside surface of the main

frame. Remove the phillips/hex head screw and washer that secure the front panel to

the printer.

Note • Belt deflection should be no more than ¼ inch (6 mm).

Caution • This installation must be performed by a qualified service technician.

Note • Print a configuration label, using the CANCEL Key Self Test, to ensure

that you can configure the new front panel to your current configuration.

Note • Caution must be used to not damage the ground cable with the

mounting screw.

Note • Note the routing of the cable inside the electronics opening. The new

cable must be routed exactly as the replaced one.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 98