Zebra Z6M Especificaciones descargar pdf (Pagina 75)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-15

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

,QVWDOOWKH3ULQW0HFKDQLVP

1. Feed the cables of the new print mechanism through the print mechanism mounting

hole.

2. Refer to Figure 4-9. Install, but do not tighten, the three mechanism mounting

screws and insulating washers.

3. Visually align the top edge of the print mechanism with the top edge of the raised

mounting surface.

4. Snug the two hex head screws at this time, leaving the Phillips head loose.

5. Latch the print mechanism.

$OLJQWKH3ULQWKHDG

1. Refer to Figure 4-10. Remove the strike plate cap by gently prying one snap tab with

a small flat-blade screwdriver. Loosen the two latch strike plate screws 1/2 turn.

Figure 4-10. Printhead Housing Adjustments

2. Refer to Figure 4-5. Set the pressure dials to position #3.

3. Refer to Figure 4-10. Install the print mechanism adjustment cam with the screw

provided in the kit on the printer frame.

Strike Plate

Screws

Print Mechanism

Adjustment Cam

Strike Plate

Cap

Print Mech Gap

Pin Gauges

Adjustment Screw

Ribbon

Guide Plat

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 75