Zebra Z6M Especificaciones descargar pdf (Pagina 68)

Page 4-8 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

4. Manually rotate the pinch and deflector rollers, clean thoroughly with solvent and a

swab.

5. Close the pivot bracket assembly.

6. Close the printhead assembly. Close media door.

Figure 4-2. Cleaning the Value Peel-Off Module

&OHDQWKH&XWWHU0RGXOH

Refer to Figure 4-3. Use the following procedure to clean adhesive off of the upper and

lower cutter blades:

1. Open media door.

2. Remove the cutter shield by removing the thumb screw and lock washer.

3. Use a swab moistened with the Zebra-recommended solvent to wipe along the upper

cutter blade.

4. To expose the lower cutter blade, turn the cutter motor thumb nut counterclockwise

until you see the “V”-shaped lower cutter blade.

5. Use a swab withe the Zebra-recommended solvent and wipe along the lower blade.

6. Replace the cutter shield.

7. When you have finished cleaning the cutter module, close the media door, plug in,

and turn on the printer. The lower cutter blade returns to its correct operating

positions.

Printhead

Assembly

Pinch

Roller

ear/Peel

Bar

Pivot

Bracket

Assembly

Deflector

Rollers

Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 68