Zebra Z6M Especificaciones descargar pdf (Pagina 96)

Page 4-36 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

19. Refer to Figure 4-29. Set your VOM (voltage ohm meter) to the lowest ohm range

and connect the meter between the main frame and the main AC input ground. The

reading must be less than one ohm.

Figure 4-29. Test the Power Supply

20. Leave the AC power cord disconnected and turn the power switch On (l).

21. Set the VOM to the highest ohm range and measure between ground and both the

return and hot terminals in the AC power module. Both readings must be in the

Mega ohm to infinite range.

22. Place the printer in the upright position and open the media door. Install the media

and ribbon and close the media door.

23. Refer to Refer to Figure 4-15. Install the electronics cover by tightening the two

screws that secure it.

24. Reinstall the media and ribbon, and close the media door.

25. Reconnect the AC power cord and restore power.

26. Turn the printer On (l).

VOM

Ground Probe

Positive Probe

Main Frame

To Chassis Ground

Caution • Stop. If the VOM readings are not as indicated, do not apply power to the

printer until the source of the problem has been corrected.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 96