Zebra Z6M Especificaciones descargar pdf (Pagina 117)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-57

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

6. Refer to Figure 4-46. Place the elastomeric connector over the stud plate. Place the

PCMCIA board against the elastomeric connector. Make sure the connector is fully

seated and both conductive elements are in place.

7. Refer to Figure 4-46. Once the alignment is achieved and the connector is fully

seated, secure the PCMCIA board to the main PC board using the washers and

thumb nuts supplied in the kit.

8. Using the screw previously removed from step 4, secure the PCMCIA board to the

standoff.

9. Refer to Figure 4-45. Secure the new cover with the two screws previously

removed.

10. Place the PCMCIA card into the cover slot to ensure the card fits into the PCMCIA

board with no obstruction.

11. Reinstall the electronics cover and tighten the two screws to secure the cover to the

printer.

12. Reinstall media and ribbon and close the media door.

13. Reinstall the AC power cord and restore power.

14. Turn the printer On (l) and print a configuration label (Cancel Key Self Test) to

ensure the printer recognizes PCMCIA option.

If the configuration label does not show “Installed………B: Memory”, remove the

electronics side cover and loosen the three thumbnails and the standoff mounting screw.

Realign the elastomeric connector to both board assemblies then retighten the thumbnails.

Run another Cancel Key Self Test to ensure proper connection.

,QVWDOO&XWWHU2SWLRQ

1. Turn the printer Off (O) and disconnect the AC power cord.

2. Refer to Figure 4-49. Open the media door and remove media and ribbon from the

printer.

3. Remove the electronics cover by removing the two mounting screws. Remove the

electronics cover.

4. Carefully remove the plastic latch cover. Slide the front cover to the right, then lift

to remove.

Note • Make sure the elastomeric connector is fully seated between the

PCMCIA board and the main PC board. If the connector is not fully seated, the

PCMCIA option will not function.

Caution • This installation must be performed by a qualified service technician.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 117