Zebra Z6M Especificaciones descargar pdf (Pagina 38)

Page 2-12 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 2SHUDWLRQV2YHUYLHZ

Value Peel Rewind (Peel-off Mode)

Refer to Figure 2-7

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.

3. Slide out the media supply guide as far from the printer frame as possible.

4. Place the roll of media on the media supply hanger.

5. Flip up the media supply guide. Slide in the media supply guide so that it just

touches, but does not restrict, the edge of the roll.

6. Feed the media under the dancer, through the slot in the transmissive sensor, and

under the ribbon sensor.

7. Pull approximately 36” (1 m) of media through the front of the printer

8. Remove the labels from about 18” of media so that only the liner remains.

9. Ensure that the media is against the back of the transmissive sensor. Then, slide in

the media guide so that it just touches, but does not restrict, the edge of the media.

10. Pull down the lever to open the pivot bracket assembly on the peel assembly.

11. Feed the media over the tear-off/peel-off bar and behind the pivot bracket assembly.

12. Close the printhead assembly.

13. Close the pivot bracket assembly.

14. Loosen the thumbscrew and slide out the rewind media guide to the end of the take-

up spindle.

15. Wrap the liner around a core placed on the take-up spindle; then, turn the take-up

spindle counterclockwise to wind up the excess liner material.

16. Slide the rewind media guide against the liner material and tighten the thumbscrew

to lock it into position.

17. Peeling will automatically start. Press the FEED key to test.

Note • Value peel option is replacing the power peel option.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 38