Zebra Z6M Especificaciones descargar pdf (Pagina 143)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-83

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

8. Carefully slide the rewind motor and spindle assembly out of the rewind pan while

guiding the media rewind cable through the hole in the bottom of the main frame.

9. Refer to Figure 4-81. Using a standard screwdriver, remove the E-ring from the

rewind shaft.

Figure 4-81. E-Ring Removal and Installation

10. Remove the flat washers and wave washer from the shaft.

11. Remove the rewind spindle from the rewind shaft.

Caution • Wear protective eyewear when removing E-rings, C-clips, snap rings, and

springs. These are under tension and could fly off while removing.

wind

Spindle

E-Ring

Rewind Spi

Assembly

Caution • Observe proper electrostatic safety precautions when handling any

static-sensitive components such as circuit boards and printheads.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 143