Zebra Z6M Especificaciones descargar pdf (Pagina 36)

Page 2-10 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 2SHUDWLRQV2YHUYLHZ

Value Peel-Off Mode with Liner Take-up

Refer to Figure 2-5.

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.

3. Slide out the media supply guide as far from the printer frame as possible.

4. Place the roll of media on the media supply hanger.

5. Flip up the media supply guide. Slide in the media supply guide so that it just

touches, but does not restrict, the edge of the roll.

6. Feed the media under the dancer, through the slot in the transmissive sensor, and

under the ribbon sensor.

7. Pull approximately 18” (500 mm) of media through the front of the printer.

8. Remove the labels from the 18” of media so that only the liner remains.

9. Ensure that the media is against the back of the transmissive sensor. Then, slide in

the media guide so that it just touches, but does not restrict, the edge of the media.

10. Pull down the lever to open the pivot bracket assembly on the peel assembly.

11. Feed the media over the tear-off/peel-off bar and behind the pivot bracket assembly.

12. Close the printhead assembly.

13. Close the pivot bracket assembly.

14. Slide the liner into the slot in the

spindle (as shown). Make sure the

liner is resting against the back

plate of the spindle assembly.

15. Turn the spindle assembly counter-

clockwise a few times so that the

liner is snug.

16. Peeling will automatically start.

Press the FEED key to test.

Note • Liner Take-up only available on Z4M.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 36