Zebra Z6M Especificaciones descargar pdf (Pagina 145)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-85

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

Figure 4-83. PCB Motor Assembly Orientation

4. Refer to Figure 4-81. Reinstall the rewind spindle using the E-ring previously

removed.

5. Carefully guide the media rewind cable through the access hole in the bottom of the

main frame while sliding the rewind motor and spindle assembly into the rewind

pan.

6. Refer to Figure 4-80. Align one of the two access holes on the rewind back plate to

one of the mounting holes on the rewind support.

7. Mount the rewind motor and spindle assembly to the printer main frame using one

of the two screws removed previously.

8. Align the other access hole of the rewind back plate to the other mounting hole on

the rewind support. Install the mounting screw and tighten.

9. Tighten the screw previously installed.

10. Refer to Figure 4-79. Reconnect the media rewind cable connector to P3 on the

main logic board assembly.

11. Replace the electronics cover and reinstall media and ribbon. Close the media door

and reconnect the power cord.

12. Turn the printer On (l). Place the printer into the power rewind or power peel mode

(see User Guide for proper set-up and media loading instructions).

Correct

Incorrect

Cable Tie

Diode

Note • For ease of alignment do not tighten the first screw until the second

screw is installed.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 145