Zebra Z6M Especificaciones descargar pdf (Pagina 94)

Page 4-34 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

12. Refer to Figure 4-27. Remove the three screws that secure the power supply board

to the printer. Remove the power supply board along with the insulator pad.

,QVWDOO3RZHU6XSSO\%RDUG

1. Refer to Figure 4-27. Place the insulator pad over the locating pins on the printer.

Verify that all holes align with holes in the main frame.

Figure 4-28. Power Supply Board Assembly Connection Locations.

2. Carefully slide the power supply board AC power switch into the opening provided,

then place the power supply board onto the insulator, insulator pad, and locating

pins.

3. Install, but do not tighten, the three screws securing the power supply board to the

main frame.

4. Install the nut plate over the main AC input and install, but do not tighten, the three

mounting screws.

Caution • Improper alignment or installation of this insulator pad can cause injury.

AC Power

Switch

Fuse (F5A 250V)

5x20mm

Main AC

Power Connection

To Printhead

Power Connection

To Main Logic

Board Power

To Stepper Motor

Power

Note • On new power supplies shipped from the factory, carefully break away

any excess scored pieces of PCB material left to protect the components during

shipping. Caution must be used to prevent damage to components.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 94