Zebra Z6M Especificaciones descargar pdf (Pagina 99)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-39

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

5. Cut the cable tie holding the panel cable to the motor wires. Disconnect the front

panel ribbon cable connector from the main logic board. Remove the cable and the

front panel.

Figure 4-31. Front Panel Installation and Connector Location

,QVWDOO)URQW3DQHO

1. Route the front panel ribbon cable from the new front panel into the machine. cable

tie the new panel ribbon cable to the motor wires. This new ribbon cable should go

around in front of the large white connector.

2. Refer to the detail in Figure 4-31 and route the new front panel ground cable

through the hole into the printer.

Cable Tie

Detail

Washer

Mounting

Screw

Front

Panel

Grounding

Cable

Access Hole

Front Panel

Data Cable

White Ferrite Block

Printhead

Data Cable

P7 Connector

Main Logic

Board

Cable Tie

Motor Wires

Note • Make sure to route the front panel ribbon cable through the notch and

away from any obstruction when replacing front panel.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 99