Zebra Z6M Especificaciones descargar pdf (Pagina 132)

Page 4-72 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

6. Refer to Figure 4-68. Install the value peel assembly with the pems to the rear and

the opening in the mounting slot to the top. Insert the mounting slot opening over

the two screws and lift up on the assembly. Now push the assembly back against the

vertical surface of the platen assembly then down so that pems are resting on the

horizontal surface of the platen housing.

7. Maintain a slight pressure downward on the value peel assembly to keep pems on

the horizontal surface, and tighten the mounting screws.

,QVWDOO3RZHU5HZLQG3HHO2SWLRQ

,QVWDOOWKH5HZLQG3DQ5HZLQG0RWRUDQG6SLQGOH

1. Turn the printer Off (O) and disconnect the AC power.

2. Refer to Figure 4-49. Open the media door and remove the ribbon and media

3. Remove and retain the two screws that secure the electronics cover to the printer.

Remove the electronics cover.

4. Carefully remove the plastic latch cover from the platen housing latch.

5. Slide the front cover to the right, then lift to remove.

6. Reinstall the plastic latch cover.

7. Refer to Figure 4-70. Loosen, but do not remove, the three screws that attach the

rear cover to the main frame and base.

Caution • Observe proper electrostatic safety precautions when handling any

static-sensitive components such as circuit boards and printheads.

Caution • This installation must be performed by a qualified service technician.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 132