Zebra Z6M Especificaciones descargar pdf (Pagina 31)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 2-5

2SHUDWLRQV2YHUYLHZ 6HFWLRQ

To place this spindle in the "normal" position, firmly pull out the spindle end segment

(plastic part only) until it clicks into place as shown in Figure 2-2. To place the spindle in

the "low tension" position, firmly push in the spindle end segment until it clicks into place.

Refer to Figure 2-2.

1. Press the printhead open lever. The printhead assembly springs up.

2. Push the ribbon roll completely onto the ribbon supply spindle.

3. Pull the end of the ribbon over the ribbon sensor, under the printhead assembly, and

out the front of the printer.

4. Close the printhead assembly, keeping the ribbon snug and free of wrinkles and in

line with the guide mark near the left edge of the ribbon guide plate.

5. Wind the ribbon clockwise onto the ribbon take-up spindle.

Figure 2-2. Ribbon Loading

5HPRYH5LEERQ

1. Break the ribbon between the ribbon guide plate and the ribbon take-up spindle.

2. While turning the ribbon take-up spindle release knob counterclockwise, squeeze

the ribbon against the ribbon take-up spindle tension blades.

3. When the tension blades collapse into the ribbon take-up spindle, hold the release

knob and rotate the used ribbon toward the rear of the printer. Then, slide off the

ribbon.

/RDG0HGLD

Tear-Off Mode

Refer to Figure 2-3.

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.

Ribbon

Supply Spindle

Ribbon Take-up Spindle

Printhead Open Lever

Ribbon

Guide Plate

Ribbon

Sensor

Spindle End Cap

Retracted

Spindle End Cap

Extended

Normal Position

Low Tension Position

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 31