Zebra Z6M Especificaciones descargar pdf (Pagina 50)

Page 2-24 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 2SHUDWLRQV2YHUYLHZ

3ULQWHU6HOI7HVWV

The Z4M/Z6M printer is designed to work with most Zebra media and ribbon

combinations. However, in some applications, changes to the printer’s configuration and

mechanical settings may be required. For these situations, printer self test labels can be

used to check print quality and ensure proper operation.

These self tests produce sample printouts and provide specific information that determines

the operating conditions for the printer.

Each self test can be enabled from the LCD Menu. Hold the – key and turn power On (

to access the menu.

&DQFHO.H\6HOI7HVW

Press and hold CANCEL while turning the printer power On (l). Release the key anytime

after the first front panel LED turns off. The Cancel Key Self Test prints a configuration

label showing:

• Printer Configuration.

• Installed Options.

• Software Version.

• Copyright Notice.

Figure 2-14 shows an example of the printer configuration label. The configuration

information will print over several labels if a label is not long enough to display all of the

configuration information at one time.

Note • When performing self tests, disconnect all data interface cables from

the printer.

When canceling a self-test before it’s actual completion, always turn the printer

power OFF and then back ON to reset the printer.

When performing these self tests while in the peel mode, you must remove the

labels as they become available.

For self test Zebra recommends using full with media. Make sure that your print

width is set correctly for the media you are using before you run any self tests,

otherwise the test may print out on the platen.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 50