Zebra Z6M Especificaciones descargar pdf (Pagina 109)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-49

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

5HSODFH5LEERQ7DNH8S$VVHPEO\

5HPRYH5LEERQ7DNH8S$VVHPEO\

1. Turn the printer Off (O) and disconnect the AC power cord.

2. Open the media door and remove media and ribbon from the printer.

3. Refer to Figure 4-15. Remove the electronic cover by loosening and removing the

two screws that secure the cover to the printer.

4. Refer to Figure 4-40. Use a hex key to loosen the two set screws on the ribbon take-

up collar that secure the collar to the shaft. Slide the collar, plastic thrust washer,

gear clutch assembly and washers off the shaft. Remove the ribbon take-up

assembly and washer.

Figure 4-40. Ribbon Take-Up Assembly/Disassembly

,QVWDOO5LEERQ7DNH8S$VVHPEO\

1. Slide the ribbon take-up assembly and washer through the bearings on the printer.

Place the washers, gear clutch assembly, plastic thrust washer and collar onto the

end of the ribbon take-up assembly shaft. Make sure the gear clutch assembly gear

meshes with the other compound gear.

2. Place a 0.020 inch feeler gauge between the thrust washer and the collar. Push in on

the other side of the ribbon take-up assembly and tighten the two screws on the

collar to secure the ribbon take-up assembly. Make sure the ribbon take-up assembly

turns freely.

3. Replace the electronics cover.

4. Reinstall media and ribbon into the printer and close the media door.

5. Reconnect power cord to the printer and restore power.

6. Turn the printer On (l) and print a configuration label using the CANCEL Key Self

Test.

Caution • This installation must be performed by a qualified service technician.

Ribbon Take-up

Assembly

Clutch

Gear

Collar

Washers

Washer

Thrust Washer

0.020 Inch

Clearance

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 109