Zebra Z6M Especificaciones descargar pdf (Pagina 146)

Page 4-86 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

3LQFK5ROOHU.LW,QVWDOODWLRQ

1. Lower pinch roller holder assembly to open position.

2. Refer to Figure 4-84. Remove the two E-rings using a small flat blade screwdriver.

Remove the bearings and roller.

Figure 4-84. Removing and Installing E-Rings and Bearings

3. Set the new pinch roller in the mounting holes in the pinch roller holder assembly.

4. Orient the bearing as shown and push the two new bearings on the shaft of the pinch

roller. Small side of bearing goes toward rollers.

5. Carefully install two new E-ring retainers in grooves in roller shaft (two extra

E-rings are supplied).

6. If you had to remove the value peel assembly, refer to steps 8 – 11 of the See “Install

Value Peel Option” on page 61., and reinstall the assembly.

Caution • Wear protective eyewear when removing E-rings, C-clips, snap rings, and

springs. These are under tension and could fly off while removing.

Note • If the E-rings are not accessible, you can remove the value peel

assembly. To do so, loosen the two screws mounting the value peel assembly

and remove it from the printer.

Groove for E-Ring

E-Ring

Bearing

E-Ring

Pinch Roller

Holder Assembly

Pinch Roller

Mounting Holes

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 146