Zebra Z6M Especificaciones descargar pdf (Pagina 140)

Page 4-80 Z4M/Z6M Maintenance Manual 77259L Rev. 4 12/16/03

6HFWLRQ 3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH

9. Refer to Figure 4-78. Cut the cable tie securing the media rewind cable to the PCB

assembly.

Figure 4-78. Cable Location

10. Disconnect the media rewind cable from the connector on the PCB.

5HZLQG0RWRUDQG6SLQGOH,QVWDOODWLRQ

1. Connect the media rewind cable to the PCB motor assembly.

2. Cable tie the media rewind cable to the outside leg of diode D1 on the PCB motor

assembly as shown in Figure 4-78.

3. Carefully guide the media rewind cable through the access hole in the bottom of the

main frame while sliding the rewind motor and spindle assembly into the rewind

pan.

4. Refer to Figure 4-77. Align one of the two access holes on the rewind back plate to

one of the mounting holes on the rewind support.

5. Mount the rewind motor and spindle assembly to the printer main frame using one

of the two screws removed previously.

6. Align the other access hole of the rewind back plate to the other mounting hole on

the rewind support. Install the mounting screw and tighten.

7. Tighten the screw previously installed.

8. Reinstall the electronics cover.

Media Rewind

Cable

Rewind

Motor/Spindle

Assembly

Cable Tie

Caution • Observe proper electrostatic safety precautions when handling any

static-sensitive components such as circuit boards and printheads.

Note • For ease of alignment do not tighten the first screw until the second

screw is installed.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 140