Zebra Z6M Especificaciones descargar pdf (Pagina 33)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 2-7

2SHUDWLRQV2YHUYLHZ 6HFWLRQ

Cutter Mode

(Cutter option required)

Refer to Figure 2-4.

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.

3. Slide the media guide out as far from the printer frame as possible.

4. Place the roll of media on the media supply hanger.

5. Flip up the media supply guide. Slide in the media supply guide so that it just

touches, but does not restrict, the edge of the roll.

6. Feed the media under the dancer, through the slot in the transmissive sensor, under

the ribbon sensor, and through the cutter module.

7. Ensure that the media is against the back of the transmissive sensor. Then, slide in

the media guide so that it just touches, but does not restrict, the edge of the media.

8. Close the printhead assembly.

Figure 2-4. Media Loading Cutter Mode

Printhead Open Lever

Printhead

Assembly

Media Supply Guide

Media Guide

Media

Supply

Hanger

Ribbon

Sensor

Transmissive

Sensor

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 167 168

Sin comentarios

Zebra Z6M Especificaciones Pagina 33